纳米WO3的制备及其光解水析氧性能研究

用溶胶凝胶法,灼烧法合成了纳米级WO3,采用X-射线衍射、紫外可见漫反射光谱对WO3进行表征.在Fe3 为电子受体、溶液酸度pH为2.0情况下,研究了纳米级WO3在365nm紫外辐射下光解水析氧的光催化活性,并讨论了不同方法制备的催化剂活性差异的原因.结果表明,结晶程度越高、尺寸越小、比表面积越大的纳米级WO3具有更高的光分解水析氧活性,电子受体的浓度、溶液的酸度对析氧活性有明显的影响.     

含语言评价信息的一种模糊多属性群决策方法

对于多属性群决策问题的处理,有时需要采用先决策、后综合的处理方法,而含有语言评价信息的多属性群决策问题,定性目标一般用语言评价信息描述,由决策人给出定性目标和权系数的语言变量评价,用梯形模糊数表示,对定量目标进行无量纲化处理;将决策人对于单一目标的评价指标聚合成多个目标的评价模糊数,采用Bass-Kw akernaak模糊数排序方法对方案进行排序;群体的评价通过Borda函数来集结方案集的群体排序.     

Efficient Multiparty Quantum Secret Sharing with Greenberger-Horne-Zeilinger States

An effcient multiparty quantum secret sharing scheme is proposed with Greenberger-Horne-Zeilinger （GHZ） states following some ideas in quantum dense coding. The agents take the single-photon measurements on the photons received for eavesdropping check and exploit the four local unitary operations Ⅰ, σx, σx and iσy to code their message. This scheme has the advantage of high capacity as each GHZ state can carry two bits of information. The parties do not need to announce the measuring bases for almost all the photons, which will reduce the classical information exchanged largely. The intrinsic efficiency for qubits and the total effciency both approach the maximal values.     

X波段介质和金属膜片混合加载行波加速结构的传播特性计算及模型腔的有关研究

计算了X波段(f=9.37GHz)介质和金属膜片混合加载行波加速结构的TM₀₁模和HEM₁₁模的色散曲线, 结果表明HEM₁₁模的截止频率比TM₀₁模的低, 说明与盘荷波导相比, 该种新加速结构单束团的BBU效应得到改善.实验研究优选得到了适用于该种新加速结构的介质(ε_r=5.812). 采用MAFIA程序优化设计了模型腔, 测试频率与设计的数值吻合得很好.     

BEPCⅡ直线加速器重大改造和束流调试进展

BEPCⅡ直线加速器的重大改造旨在获得高流强、小发射度和小能散的正负电子束, 以满足对撞机亮度提高两个两级的要求. 这对直线加速器各系统和束流物理是一个挑战. 文章介绍了直接决定束流性能的新电子源、新正电子源、新微波功率源、相位控制系统和束流测量系统等的改造情况; 叙述了束流物理研究; 介绍了束流调试进展情况和进一步改进计划.     

聚变等离子体中的快离子压强

本文运用Fokker-Planck方程的慢化近似,考虑存在多种离子成份(包括杂质),假定它们具有共同的温度,我们得到了聚变产生的快离子压强的简单封闭形式表示式。表明在典型的工作温度下(～60keV),D-~3He等离子体中聚变产生的快离子压强约为本底热压强的20％,这与D-T等离子体工作在20keV时的比值几乎相同。因此,D-~3He和D-T在它们相应的预期工作温度下,它们各自的快离子压强对总压强的影响是类似的,然而在更高的温度下,这个比值将变得更大。     

Interface solution for writing-induced nano-deformation of slider body

Writing-induced nano-deformation of slider body becomes a big concern when the mechanical spacing between the head and disk is continuously reduced to achieve higher magnetic recording areal density. Reduced head–disk spacing increases the risk of head/disk contact and causes the thermal instability in head–disk interface (HDI). This paper reports authors’ efforts towards exploration of interface solutions for writing-induced instability in ultra-low head–disk spacing magnetic system. Multi-shallow step structure with optimized rail position is analyzed and a new femto slider with such structure is explored. The results of numerical simulation indicate that the multi-shallow step structure is an effective approach in reducing the flying height change caused by the writing-induced nano-deformation of the slider body.     

Crystal-Orientation Dependent Evolution of Edge Dislocations from a Void in Single Crystal Cu

The micro-void growth by dislocation emission under tensile loading is explored with focus on the influence of crystal orientations. Based on the elastic theory, a dislocation emission criterion is formulated. It is predicted that the preferential location of dislocation nucleation and its threshold stress are dependent on the crystal orientation. Large-scale molecular dynamics （MD） simulations are also performed for single crystal copper to illustrate the dislocation evolution pattern associated with a nano-void growth. The results are in line with those given by the theoretical prediction. As revealed by MD simulations, the characteristics of void growth at micro-scale depend greatly on the crystal-orientation.     

纳米累托石-TiO2光催化剂的制备及表征

以TiCl4和累托石为主要原料，制备出纳米累托石-TiO2粉末，并用X-衍射、透射电镜等对其进行表征．结果表明：纳米累托石-TiO2粉末平均直径为17．5nm当焙烧温度从500℃升至800℃时，累托石-TiO2粉末的比表面积从65．7m^2／g下降至3．3m^2／g，单位质量吸附剂的孔体积从0．1430cm。／u降到0．0213cm^3／g；当焙烧温度从300℃上升至500℃时，孔径变化不大，属中孔范围；当焙烧温度升至800℃时，一些孔道出现坍塌，不利于纳米累托石-TiO2粉末的光催化活性．     

红外光谱预处理中去噪的研究

红外(IR)光谱由于包含了噪声等各种外界干扰因素.应该先进行光谱预处理,以便降噪,提高分析准确度.本文采用了一种基于最优小波包基的信号去噪算法,该算法根据最小代价原理,采用不同的阈值算法对光谱的高频和低频信号进行量化处理,用量化后的系数重构得到去噪信号,从而达到较好的去噪效果.实验表明,本方法处理后光谱曲线非常光滑、噪声消除效果明显.